We're going to slightly modify the hoodtops.  We're going to pie cut them 3/8" at the front to nothing at the rear.  Although this is not much, hopfully it will make the front of the hood less 'heavy' looking, without being noticable.
	Here the hood has been cut just above the body line.  Care was taken to cut very straight with very little heat build-up
	Once the 3/8" has been removed from the front, we carefully clean up the edge so it is a tight fit from one end to the other.
	Here the hood has been TIG welded and lightly sanded.  It will be finished up once back on the car (it's held into place better, making it easier to work with).