We're using some SoCal headlight mounts,but we need to modify them.  We're going to drill them out, also lower them slightly and turn the base a bit.
	At this point, we've cut them in half.  We'll drill out the centers in both directions to run the wires through.
	We've cut the base off, which will allow us to mount them a little farther back (by turning them slightly forward).
	We've already welded and polished the center area, and just finished welding the base back on.  We just need to sand/polish and they're ready to mount.
	Done.  We're really happy with the final location.