Now that the front half of the interior is done, we'll move on to the rear.  We'll have flared holes wrapping around the interior, with steel panels below
	Here's the beginning of the flared hole piece.
	Started on the lower panel - eventually this piece will get a diamond stitched leather panel insert.
	This panel is complete - now to move on.
	The flared hole pieces are now complete.  The center piece removes, then the outer pieces will have room to come out.  We still need to make the lower part, then bracing across for added rigidity.
	The outer edge is made - we just need to make the insert.  Unlike all of the other panels, this one will be painted with no diamond leather insert.
	After some time with the English wheel (to get the slight dish in the panel both side to side and top to bottom), it's welded in.  Also added are the latch handles.  Should look pretty neat chromed against the black.
	Here's a shot with the seats added.
	We also made some nice door stops - patterned off of a closed car stop...