We started with some aftermarket pieces.  They didn't fit well anywhere, so we cut them apart.  This will allow us to get a better fit around the tank/frame rails and to the fender, and also make them look a little nicer.
	One area that was obvious was around the taillight stand.  We wanted to make the apron fit around the stand better.  The oval represents where the stand bolts to the apron.
	We're finished with this one.  We also reshaped the curved area to better match up with the rear fender, and also narrowed the top portion to "lighten" it up a bit.  They have also been modified to fit around the tank and spreader bar much nicer.